Humidifier conversion to use acrylic polymer crystals

Acrylic polymer crystals - humidifier conversion.

The instructions and picture guide can be followed to convert your sponge based humidifier to use the acrylic polymer crystals supplied in our conversion kit, or for the Humidoro™ humidors which are all supplied as standard with a conversion kit.

If you have any questions, please contact us. We are always happy to be of assistance.

WARNING WARNING WARNING
Keep acrylic polymer crystals out of the reach of children!
They can be harmful if swallowed!
WARNING WARNING WARNING

Humidifier block with sponge element, bag containing acrylic polymer crystals and bottle of distilled water.
Gently open the humidifier block by prising apart the top and bottom pieces.
Place the top of the humidifier block to one side. Remove the sponge element and discard. Clean away any remnants (or dust) left from the sponge humidifier element from the bottom of the humidifier block.
Empty the bag containing the acrylic polymer crystals into the lower half of the humidifier block.
Spread the acrylic polymer crystals evenly in the lower half of the humidifier block.
Add a little distilled water. Immediately the acrylic polymer crystals will start to absorb it and grow in size.
Monitor and keep adding small amounts of distilled water as it is absorbed into the acrylic polymer crystals.
Repeat the process. Monitor and keep adding small amounts of distilled water as it is absorbed into the acrylic polymer crystals.
Within an hour you will notice that the crystals have expanded considerably as they have absorbed the distilled water. In this picture the crystals have grown so that they are a little above the top edge of the humidifier block. Stop adding distilled water.
Re-fit the top of the humidifier block. Give the humidifier, (grate facing down), a gentle shake over a sink to allow any un-absorbed water to fall through the grate. In the event that the humidifier is going to be placed in the lid of a humidor with the grate facing downwards, stand the humidifier face-down on a sheet of kitchen towel for an hour to ensure that there is no possibility of any water dripping out onto expensive cigars when the humidifier is placed back in the humidor.

If you have any questions, please contact us. We are always happy to be of assistance.

WARNING WARNING WARNING
Keep acrylic polymer crystals out of the reach of children!
They can be harmful if swallowed!
WARNING WARNING WARNING

Disclaimer

The instructions and picture guide are provided free of charge to assist our customers. A little common sense goes a long way when putting objects containing water into close proximity with expensive cigars.

Except in relation to liability that cannot be lawfully excluded, we do not accept responsibility for any loss or damage, however caused (including through negligence), which you may directly or indirectly suffer in connection with your use of this website or any linked website, nor do we accept any responsibility for any such loss arising out of your use of or reliance on information contained on or accessed through this website.